BBIT / BPTM

Busbar Insulation Tubing

     Here we are looking at two different products.  One is BBIT - Bus Bar Insulation Tubing.  The other is BPTM which is a medium wall tubing with a slightly lower voltage rating. 

     BBIT is a heavy wall tubing for use on straight or bent bars where maximum clearance reduction...or 35 kV insulation is required.

     BPTM is a medium wall tubing for use on straight or bent bars where some clearance reduction or 25kV insulation is required.  These heat shrinkable tubes for straight and bent busbars are extremely flexible, allowing them to be easily positioned on busbars and quickly installed using a gas torch or oven.  They have a high expansion ratio, so each size of tubing fits a range of busbar sizes.  Both BBIT and BPTM tubing are ideal for original equipment assembly and for retrofit applications where access to one end is available. 

    Both BBIT and BPTM tubings are also ideal for protection against accidental bridging caused by birds and animals. 

    BBIT:  5-35kV
    BPTM: 5-25kV

     Available sizes:
BBIT 25/10-A/U
BBIT 40/16-A/U
BBIT 65/25-A/U
BBIT100/40-A/U
BBIT 150/60-A/U
BBIT 175/80-A/U

BPTM 15/6-A/U
BPTM 30/12-A/U
BPTM 50/20-A/U
BPTM 75/30-A/U
BPTM 100/40-A/U
BPTM 120/50-A/U
BPTM 175/70-A/U
BPTM 205/110-A/U
BPTM 235/130-A/U

Motor Connection Kits

MCK and MCK5

Raychem / Tyco MCK

Raychem / Tyco MCK-5

     MCK is available in a number of different variations.  Which one do you need?  That all depends on what you're working with. 

     Type V: The type V kit is designed to splice the stub or butt configuration that is commonly used where there is insufficient room to make in line connections.
     Type L:  The type L kit is used where space permits to splice in line connections.

     MCK-5 is rated to the general electrical requirements of the IEEE-48 withstand tests.

    For use as an in line or stub splice between 1/C poly feeder cable and motor leads.  Tyco Electronics (formerly Raychem) motor connection kit provides excellent insulation sealing and resistance to abrasion in motor connections.

MCK Stub Installation

Common standard sizes are:

MCK-1V

MCK-2V

MCK-3V

MCK-4V

MCK-1L

MCK-2L

MCK-5-1V

MCK-5-2V

MCK-5-3V

MCK-5-1L

MCK-5-2L

High Voltage Splice

High Voltage Splice (with Armored Cable)

     Non shielded cable splices provide high abrasion resistance and a positive environmental seal.  Kits accomodate both jacketed and unjacketed cable.  Rated to meet the applicable portions of IEEE404.

Key:
A: Insulation Diameter
B: Jacket OD
C: Connector Max OD
D: Max Length
L: Kit Installed Length
M: Required Installation Space

Standard Sizes:

HVS-500

HVS-501

HVS-502

HVS-503

HVS-3-501

HVS-3-502

HVS-3-503

HVSA-3-501

HVSA-3-502

HVSA-3-503