Elbow Modular Splicing System

ELB-15/28-600 Elbow Modular Splicing Systems

600 Amp (15-35 kV) Class for Deadbreak T-body Elbow Connector

TE’s Raychem Elbow Modular Splicing System offers separable solutions to fit a variety of needs
which include: splicing, connecting to apparatus, dead-ending, and the ability to easily reconfigure
circuits. At 15-35 kV 600 Amp, the following options are available: 2-way, 3-way, 4-way, or dead-end
connections.

These kits use TE Connectivity’s standard T-bodies, connecting plugs, insulating plugs, and
conductive caps. They are fully shielded and fully submersible and meet the requirements of IEEE
Standard 386. They are interchangeable with other manufacturers’ products that conform with this
industry standard.

• Peroxide cured EPDM rubber ensures low tension set and high dielectric strength
• 100% factory production tested for partial discharge and AC Hipot per IEEE 386
• Fits 15-35 kV cables up to 1250 kcmil
• Both compression lugs and range taking shearbolt connectors are available, along with the
  required cable adapter (sold separately)
• Designed for use on extruded (XLPE or EPR) solid dielectric cable

Note: 600 version is without testpoint and 610 version is with test point.

Modular Elbow Splice kits do not include connectors or cable adapters.

Approximate Width of Splicing System Rated for use at 15/28 kV

Deadend (One Way) Assembly has an approximate width of 256 mm.

 Two Way Assembly has an approximate width of 483 mm.

 Three Way Assembly has an approximate width of 709 mm.

Four Way Assembly has an approximate width of 935 mm.

Approximate Width of Splicing System Rated for use at 35 kV

Deadend (One Way) Assembly has an approximate width of 307 mm.

 Two Way Assembly has an approximate width of 584 mm.

 Three Way Assembly has an approximate width of 861 mm.

Four Way Assembly has an approximate width of 1138 mm.